Suitable to cut and trim cores to be prepared for compression tests, where the flatness of both surfaces is a basic condition to obtain correct results.
The equipment is made of stainless steel and aluminum and it is supplied complete with diamond blade dia. 180 mm.
For this purpose it must be used the drill mod. C377-10 (enclosed into micro-coring equipment) and the water tank with foot pump mod. C377-01.
Note: The maximum values foreseen for compression tests on micro-cores are usually lower than 60 kN.
Portable compression machine mod. C094 (see the relevant section), or a cement compression tester (see the relevant section) may be conveniently used.
Trimming of cores may be even obtained with the grinding machine mod. C298300-10 + device mod. C300-08 (see the relevant sections)
