4PB Servo-Pneumatic Four Point Bending System

Code: B210-KIT

The 4PB Four Point Bending System from Pavetest is a servo-pneumatic testing machine designed for the flexural testing of asphalt beams. Using digital control of a high-performance servo valve, the system provides precise loading waveforms up to 60 Hz in either haversine or sinusoidal mode.

This system allows testing in controlled strain or controlled stress mode, enabling accurate determination of flexural stiffness, modulus, and fatigue resistance for asphalt specimens of varying sizes.

The machine comprises:

B210-01: Servo-pneumatic Four Point Bending (4PB) Device with 10 mm actuator LVDT, ±5 kN load cell and 2 mm On-specimen LVDT
B209-08: 8 Channel Control and Data Acquisition System (CDAS2) and TestLab software
B270-12: Air Reservoir assembly with membrane dryer

Вы не вошли в систему для просмотра руководств, Войдите

B210-04N

Load cell capacity ± 5 kN
B210-05N

Actuator LVDT 10 mm

LOAD FRAME:

Outer clamp span 355.5 mm (14”) and 420 mm
Nominal beam size(s): 50 mm (h) x 50 mm (w) 50 mm (h) x 63.5 mm (w) 70 mm (h) x 70 mm (w) 70 mm (h) x up to 85 mm (w)

SERVO ACTUATOR

Capacity ± 5 kN
Frequency Up to 60Hz;
Stroke 10 mm
Air supply clean dry air
Pressure 800-900 kPa
Minimum rate up to 7 litres/sec

ON-SPECIMEN TRANSDUCER

Range ± 1 mm
Resolution 0.0002 μm
Accuracy Better than 5 μm

Power Supply: 90-264V 50/60Hz 1ph 240W (B210-KIT)

Dimensions: 590(h) x 250(d) x 570(w) mm (B210-01) 410(h) x 250(d) x 570(w) mm (B212)

Weight: 45 kg approx. (B210-01) 35 kg approx. (B212)

Servo-pneumatic control with high-precision waveform shaping up to 60 Hz
Capable of haversine or sinusoidal waveforms
Measures flexural stiffness/modulus and fatigue resistance of asphalt beams
Integrated CDAS digital controller and TestLab software for data acquisition and analysis
Compact, stand-alone design for laboratory use
On-specimen LVDT for accurate displacement measurementa

4PB – Stand-Alone Servo-Pneumatic Four Point Bending System

Асфальт